Email this article from PlasticsNews.com

Sytrama robot integrates in-mold labeling

Sacmi Group’s Sytrama robot unit showed the new 811G high-speed, side-entry robot running at NPE2012 on a Negri Bossi Janus injection molding press. The robot was integrated into a demonstration of in-mold labeling, making a two-cavity thin-wall container with a five-sided label. Cycle time was 4.9 seconds.

To send to multiple addresses, simply separate each address with a comma. Example: abc@abc.com, xyz@xyz.com. Please limit to a maximum of 5 recipients.

Most Popular