Illinois governor vetoes plastic bag law

By Don Loepp
Editor

Published: August 26, 2012 6:00 am ET

Related to this story

Topics Public Policy, Sustainability, Packaging, Film & Sheet, Recycling

CHICAGO (Aug. 26, 11:15 p.m. ET) — Illinois Gov. Pat Quinn has vetoed a plastic bag recycling bill that would have made it more difficult for most communities in the state to ban single-use plastic bags.

Quinn vetoed the bill on Aug. 26. The legislation had been supported by some plastic bag manufacturers.

“While well-intentioned, this legislation is a roadblock to innovation that would do little to boost recycling in Illinois. We can do better,” Quinn said in a statement. “Let’s not tie the hands of innovative Illinois municipalities that are laboratories of reform for Illinois."

The bill would have prevented all communities in Illinois except Chicago from banning single-use plastic bags.

The bill had attracted nationwide attention, with environmentalists lining up against it, even though it would have aimed to increase recycling of plastic bags and other plastic films.

The veto is a victory for Abby Goldberg, a 13-year-old from Grayslake, Ill., who had launched a petition drive against the bill. Goldberg wanted her community to ban plastic bags, and in July she personally delivered a petition with more than 150,000 signatures urging the veto.

On Aug. 26, Goldberg sent a message to her Twitter followers that the battle is not over.

"OK, thanks are done, time to role up our sleeves again!" she wrote to backers who were congratulating her on the victory. "Encourage [Illinois] legislators to not override veto!!!!!!" she wrote.

The veto is a loss for the plastics industry, which had supported the bill. David Asselin, executive director of the American Progressive Bag Alliance, recently said the bill was "good for our environment and good for Illinois’ economy," in a letter to the Springfield, Ill., Journal Register.

"What’s more, it was based on the optimistic notion that middle ground can be found, that compromises in legislation are still possible, and that they work. Policy can work to the benefit of all involved when entrepreneurs and government work together. This is how policy should be made," Asselin wrote.

The bill would have forced bag manufacturers to register with the state, pay a $500 registration fee and develop a plan to recycle the bags. According to the bill, at least 75 percent of the state’s population would be required to live within 10 miles of a plastic bag recycling drop-off area by 2014. That number rises to 80 percent in 2015.

Also, the percentage of recycled plastic bags would have increased by 12 percent between 2014 and 2015. If the recycling increase fell short, manufacturers would have had to detail why it was not met.


Comments

Illinois governor vetoes plastic bag law

By Don Loepp
Editor

Published: August 26, 2012 6:00 am ET

Post Your Comments


Back to story


More stories

California lawmakers give final approval to plastic bag ban

August 30, 2014 6:00 am ET

Under the measure, single-use plastic bags will be barred from California retailers, including grocery stores, convenience stores and drug stores, as ...    More

Image

Poor plastic coating prompts cable recall

August 29, 2014 2:10 pm ET

Australia's competition regulator, the Australian Competition and Consumer Commission (ACCC), has ordered a major recall of 2,485 miles of electrical ...    More

Image

EPA fines RI polymer company

August 29, 2014 1:20 pm ET

A Rhode Island polymer manufacturer has reached a $60,000 settlement with the U.S. Environmental Protection Agency (EPA) for violating federal clean...    More

Image

Tighter resin prices leading to price hike for PE film

August 29, 2014 11:13 am ET

One of North America's largest film makers is pushing through a polyethylene price increase due, in part, to the tight resin market.    More

Image

Green trend boosts plastic building materials business in China

August 29, 2014 9:42 am ET

The greening of China's domestic building materials market is giving the plastics industry a boost.    More

Market Reports

Thermoformed Packaging 2014 Market Review & Outlook North America

This in-depth report analyzes economic and market trends, legislative/regulatory activity impacting supply and demand, business opportunities and threats, materials pricing, manufacturing technology, as well as growth strategies being implemented by thermoformed packaging companies.

Learn more

Pipe, Profile & Tubing Extrusion in North America 2014

U.S. demand for extruded plastics is expected to grow by 3 percent in 2014, with PVC remaining the largest segment.

Plastic pipe will post the strongest gains through 2018, continuing to take market share from competing materials in a range of markets.

Our latest market report provides in-depth analysis of current trends and their financial impact on the pipe, profile and tubing extrusion industry in North America.

Learn more

2014 Injection Molding Industry Report

GROWTH, OPPORTUNITY IN SIGHT FOR INJECTION MOLDERS IN 2014

In the wake of the economic turbulence earlier in this decade, molders today find themselves in much better shape. Molders are gaining a competitive advantage by investing in people, equipment and seeking inroads into new markets on a global scale.

Growth in the injection molding industry is going to be driven by low financing costs and a continued move to reshore some business.

Learn more

Upcoming Plastics News Events

September 10, 2014 - September 12, 2014Plastics Caps & Closures 2014

January 14, 2015 - January 14, 2015Plastics in Automotive

February 4, 2015 - February 6, 2015Plastics News Executive Forum 2015

More Events