Report offers alternatives to extended producer responsibility

Published: September 14, 2012 6:00 am ET

Related to this story

Topics Sustainability, Packaging

PITTSBURGH (Sept. 14, 1:25 p.m. ET) — A cost analysis done for the Grocery Manufacturers Association argues that alternatives to extended producer responsibility policies can achieve high municipal solid waste recycling rates at reasonable costs and address a wider spectrum of the waste stream.

The report, released at the Sustainable Forum in Pittsburgh on Sept. 12, also claims that mandatory EPR programs aimed at food, beverage and consumer product packaging would not deliver on their promise of creating more cost-effective residential recycling programs and driving packaging redesign.

The report analyzed recycling rates, system costs, packaging changes, and other data from various European and Canadian jurisdictions that employ EPR for packaging. In the U.S., it looked at nationwide recycling rates and recycling programs in Ramsey County, Minn.

Among the study’s principal findings:

• Packaging use has declined in the United States, where there is no packaging EPR, but it has increased slowly in Europe, where there is widespread packaging EPR.

“There is no indication that EPR has reduced packaging use economy-wide or had any effect on package design or selection,” said the 68-page report, prepared for GMA by SAIC Energy, Environment & Infrastructure, LLC.

• Price signals sent by EPR to manufacturers are very weak in most jurisdictions compared to the overall value of the products they contain and price of packaging.

“Packaging EPR generally does not change the relative package cost among different package alternatives for a product,” said the report. “There is insufficient EPR fee differentiation to cause consumer packaged goods companies to switch from one package format to another.

The study also said that the U.S. has a higher recycling rate for municipal solid waste than both the European Union, 23 percent, and Canada, 18 percent, where EPR is widely employed.

It also noted that Ramsey County, a non-EPR jurisdiction in the Minneapolis-St. Paul area, has a lower net cost per ton ($156) than EPR programs in the Canadian provinces of Manitoba and Ontario, where costs are $166/ton and $202/ton, respectively. However, the report did not look at costs in any other specific municipalities in the U.S.

The report further argued that “states and municipalities already have at their disposal a suite of non-EPR policies that are both effective and efficient in terms of raising recycling rates.”

Specifically, the report cited more than a dozen approaches including disposal limits, recycling rewards or rebates for consumers, penalties, pay-as-you-throw disposal pricing, disposal bans, mandatory recycling of certain materials, diversion goals, landfill surcharges or taxes, advanced recycling/disposal fees, mandatory retail take-back programs, and building design standards.

“Together, [these initiatives] can achieve high recycling rates, without excess cost or administrative burden that results from EPR,” the report said.

“The most successful recycling and waste recovery programs will result from comprehensive approaches that leverage industry innovation and collaborative partnerships between NGO’s, government and industry, not one-size-fits-all mandates,” asserted Meghan Stasz, senior director of sustainability at GMA.


Comments

Report offers alternatives to extended producer responsibility

Published: September 14, 2012 6:00 am ET

Post Your Comments


Back to story


More stories

Image

British consumers still want their squeeze bottles when it comes to ketchup

April 16, 2014 10:02 am ET

Research commissioned by the British Plastics Federation's packaging group shows that when it comes to the nation's favorite tomato ketchup, 77...    More

With European Parliament vote looming, official urges bag restriction

April 16, 2014 9:56 am ET

Janez Potocnik, Europe's commissioner for the environment, told the European Parliament April 15 that plastic shopping bags are a “highly...    More

Image

Austria's Greiner building a foothold in the US rigid packaging market

April 15, 2014 1:22 pm ET

Greiner Packaging International GmbH, one of Europe's largest makers of rigid plastic packaging, now wants to make its mark in the United States.    More

Image

SodaStream turns to PET for its new pre-measured flavor 'Caps'

April 15, 2014 1:40 pm ET

SodaStream International Ltd., maker of home beverage carbonation systems, is using plastic to bring more flexibility to its consumers.    More

Plastics recycling rates in Michigan will go up, if new initiative works

April 14, 2014 4:15 pm ET

Clean Tech, a unit of Plastipak Packaging Inc., expects to recycle about 6 billion plastic bottles this year and has an eye on 10 billion plastic bott...    More

Market Reports

Thermoformed Packaging 2014 Market Review & Outlook North America

This in-depth report provides analysis and discussions of economic and political conditions, market trends, legislative/regulatory activity impacting supply and demand, business opportunities and threats, materials pricing, manufacturing technology, as well as strategies being implemented by thermoformed packaging companies. In addition, there are reviews of 25 leading thermoformers in the packaging segment, assessing their growth initiatives and performance metrics over 10 years.

Learn more

Automotive Market Review and Outlook 2014 The Americas

This 75-page report features in-depth analysis of the automotive industry for the Americas. It includes discussions of market trends, legislative/regulatory activity impacting production and threats as well as design strategies being implemented by the major automakers. Detailed charts and data tables outline North American automotive production over the last five years.

Learn more

Plastics Building & Construction Market Review and Outlook 2014 with MS Excel chart data

This report provides in-depth analysis of the plastic building and construction market for North America, including discussions of trends, opportunities, threats and the latest developments in construction trends that impact plastics processors.

Learn more

Upcoming Plastics News Events

May 6, 2014 - May 8, 2014Plastics in Medical Devices 2014

May 12, 2014 - May 12, 2014Plastics News Brazil Pharma Summit

September 10, 2014 - September 12, 2014Plastics Caps & Closures 2014

February 3, 2015 - February 7, 2015Plastics News Executive Forum 2015

More Events