Calif. cracks down on illegal bottle, e-waste redemptions

Jeremy Carroll

Published: September 27, 2012 6:00 am ET

Related to this story

Topics Packaging, Sustainability, Public Policy, Recycling

SACRAMENTO, CALIF. (Sept. 27, 12:30 p.m. ET) — In an effort to deter the importation of aluminum cans, plastic and glass bottles into California to be redeemed, Gov. Jerry Brown signed new restrictions on the state’s bottle bill.

The bill requires those importing 25 pounds of aluminum or plastic, or 250 pounds of glass containers to report the volume to CalRecycle, the state department that oversees the bottle redemption program. Assembly Bill 1933 would also require a vehicle entering the state that contains more than 25 pounds of empty beverage container material to pass through the nearest plant quarantine inspection station and obtain proof of inspection from the department, said the bill’s sponsor Assemblyman Rich Gordon.

In 2010, CalRecycle and the state’s attorney general’s office made 31 arrests of illegal collection of $3.5 million in redemption funds over several years. Those individuals were hauling truckloads of cans and bottles from neighboring states and collecting the 5-cent redemption fee without paying the deposit on the purchase.

“California’s successful Bottle Bill Program is creating green jobs while protecting the environment by encouraging recycling,” Gordon said in a statement. “It is important that we protect these programs from individuals who are attempting to exploit them.”

Brown also signed Assembly Bill 549 which attempts to stop fraudulent claims against the state’s e-waste program, but specifically outlining that electronics purchased outside of the state can not be redeemed through the state system. In California, consumers pay an electronics fee at the time the purchase which goes toward the recycling of the device.


Comments

Calif. cracks down on illegal bottle, e-waste redemptions

Jeremy Carroll

Published: September 27, 2012 6:00 am ET

Post Your Comments


Back to story


More stories

Image

P&G adding label to help guide consumers in recycling

March 2, 2015 3:29 pm ET

Procter & Gamble Co. will help prompt consumers to recycle rigid packaging by joining the Sustainable Packaging Coalition's How2Recycle Label program.    More

Image

Toyota says Mirai fuel cell sedan represents a 'new start' for the carmaker

March 2, 2015 11:55 am ET

Toyota Motor Corp.'s most advanced vehicle, a car that runs on hydrogen and emits only water, has had an ironically low-tech birth and has an equally ...    More

Image

SPE CEO points to 'open-source' trends as sign of need to share information

March 2, 2015 11:44 am ET

Willem De Vos, the CEO of the Society of Plastics Engineers, took a Plastics News Executive Forum audience on a wild ride into the future.    More

Image

Ukrainian crises eats into plans for building materials firm Masterplast

March 2, 2015 10:03 am ET

Hungarian building materials manufacturer Masterplast Nyrt. saw its earnings fall in 2014 after the worsening Ukraine crisis forced it to write off...    More

Image

Recycling trade group growing in size, resources

February 27, 2015 4:50 pm ET

DALLAS — The executive director of the Association of Postconsumer Plastic Recyclers is partial to calling his group the little engine that coul...    More

Market Reports

Flexible Packaging Trends in North America

North America represents about 30 percent of the global consumption of flexible packaging. Annual growth in this region is forecast at 4 percent during the next 5 years.

For more insight on growth opportunities, drivers of growth and the outlook for 2015, download this report.

Learn more

Plastics Recycling Trends in North America

This report is a review and analysis of the North American Plastics Recycling Industry, including key trends and statistics based on 2013 performance. We examine market environment factors, regulatory issues, industry challenges, key drivers and emerging trends in post-consumer and post-industrial recycling.

Learn more

Plastics in Mexico - State of the Industry Report

This report analyzes the $20 billion plastics industry in Mexico including sales of machinery & equipment, resins and finished products.

Our analysts provide insight on business trends, foreign investment, top end markets and plastics processing activity. The report also provides important data on exports, production, employment and value of plastics products manufactured.

Learn more

Upcoming Plastics News Events

June 2, 2015 - June 3, 2015Plastics Financial Summit - Chicago 2015

September 16, 2015 - September 18, 2015Plastics Caps & Closures - September 2015

More Events