Diamond America Corp. said its TL-350 extruder has a swing-arm controller, which allows the operator to work at the die area while programming the extruder, for faster setup.
When used in coextrusion, the controls are located in the same panel as the main extrusion controls.
The Tallmadge, Ohio, company said it can put the swing-arm feature on any size extruder. The TL-350 has a screw diameter of 3½ inches and a length-to-diameter ratio of 30-to-1.
Tel. (330) 633-9959, fax (330) 633-9557, e-mail [email protected]