Priamus System Technologies AG of Shaffhausen, Switzerland, now offers a compact version of its Fill & Cool for balancing melt flow in hot-runner systems.
The Fill & Cool system automatically optimizes fill time by controlling melt flow and mold cooling. The mold-cavity temperature sensors also are used for controlling melt flow to cool circuits in the mold — simultaneously controlling the surface temperatures of the cavities.
Fill & Cool is designed for up to 128 measuring channels, but the new version is limited to eight. The system has an option to switch over to holding pressure, automatically, at the correct time to compensate for variations in material viscosity.
Also new is a compact Pass controller that shows at a glance if parts are good or bad, by displaying curves and bar charts. It saves specific data for each part, including information on cavity pressure and temperature.
U.S. unit Priamus System Technologies LLC is based in Bruns¼wick, Ohio.
Tel. 877-774-2687, e-mail [email protected]